Get in Touch with GUANGQI
DD
I write about outdoor lighting technologies and the details that matter during a retrofit or facade project. My articles examine sodium-vapor street lights and colored flood lighting, including control and beam considerations. I aim to help readers distinguish existing equipment behavior from the requirements of a proposed LED installation.
Light Pollution Solutions: Shielding, Aiming, Controls, Spectrum, and Curfew Design
By DD · Updated October 2026 Effective light pollution solutions illuminate a target, keep light out of unwanted areas, and decrease its output or operating time when conditions allow. A warmer lamp, for instance, doesn’t correct a floodlight aimed at…
Halogen Flood Light: Wattage Equivalents, Heat, Beam Quality, and LED Replacement
By DD · Updated October 2026 When replacing a halogen flood light, match the type of lamp first, then voltage, light output and beam coverage. A lower wattage LED can reduce energy consumption, but a bad choice can leave the…
Industrial LED Bulbs: Base Types, Voltage, Thermal Limits, and Retrofit Checks
![Industrial LED Bulbs: Bases, Voltage & Heat [Checklist]](https://gqlamp.com/wp-content/uploads/2026/10/industrial-led-bulbs-blog-featured-768x512.png)
Industrial LED bulbs are replacements for lamps used in industrial or commercial fixtures. Modern lighting still requires a product match. An exact screw base is only part of the conversion; the actual lamps must also match the supply and conversion…
Lighting Control Panel: Components, Circuits, Protocol Gateways, and Commissioning
Updated October 2026 Quick specification priorities Define controlled load and zone, identify driver interface, document each gateway function, agree on witnessed acceptance before ordering. A lighting control panel can switch a warehouse aisle, dim an office perimeter, or coordinate an…
Sodium-Vapor Street Light: Identification, Warm-Up Behavior, Failures, and LED Retrofit Data
Municipal, commercial, and facility lighting field guide August 2026 A sodium vapor street light is a gas-discharge lighting system, not simply any fixture that looks orange. Low-pressure sodium and high-pressure sodium use different lamp constructions and operating systems. Identification must…
Colored Flood Lights: RGBW Control, Beam Mixing, Facade Use, and Specification Risks
Specification guide for lighting designers, controls engineers, procurement teams, and project owners · Updated August 2026 Colored flood lights are a system, not a color swatch. The approved result depends on the exact luminaire, color channels, driver or decoder, controller,…
Underwater Pond Lights: IP68 Sealing, Cable Runs, Beam Placement, and Maintenance
Updated August 2026 Underwater pond lights are submersible luminaires used to reveal pond features after dark. A suitable system also requires the fixture, cable route, connections, controls, and maintenance path to fit the intended water environment. Planning Snapshot Immersion evidence:…
Lumens vs Lux: How to Convert Light Output into Target-Surface Illuminance
Lumens vs lux explained with formulas, worked examples, and target-surface checks. Convert light output into auditable illuminance for real projects.
LED Basketball Court Lighting: Lux Targets, Pole Layout, Glare, and Fixture Count
LED basketball court refers to the lighting system above or around the playing surface in this guide, not an LED glass floor or video court. Good design puts maintained light where players, officials, spectators, and cameras need it without leaving…
Remote-Control Light Switch: RF, Wi-Fi, Relay Load, Range, and Commercial Limitations
A remote control light switch is a user interface that sends a command to a load-switching device. That simple definition hides the engineering decision. An in-wall switch, receiver module, plug-in unit, or powered fixture still switches the electrical load. “RF,”…
